Forums

Resolved
1 votes
I'm trying to install and Test ClearVM. I downloaded the ISO and booted from USB. It gives an error about unable to get an IP address from DHCP. So I downloaded the ISO again, but this time specified a static IPv4 address. When I boot it goes into a loop about "attempting to find IPv4 address x.x.x.x with ARP ping".

I'm installing on an Intel NUC. Do I need to supply NIC drivers and merge them into the Witsbits ISO installer?

Thanks!
In ClearVM
Friday, January 27 2017, 06:57 PM
Share this post:
Responses (2)
  • Accepted Answer

    Saturday, January 28 2017, 12:08 AM - #Permalink
    Resolved
    1 votes
    Does the install show its reading your eth ports?
    The reply is currently minimized Show
  • Accepted Answer

    Monday, February 13 2017, 08:16 PM - #Permalink
    Resolved
    1 votes
    In neither of the two install modes (DHCP or Static IP) does it ever get to a command prompt or GUI. In both cases it just loops continuously at either searching for DHCP or attempting to find IP.

    I"m wondering if I need to slipstream some ethernet drivers into the install ISO or something? I can install Linux Mint onto the same hardware without any problems getting dhcp.

    Thoughts?
    The reply is currently minimized Show
Your Reply