I was running Clearos 7 i installed 2 yrs ago. My harddrive failed so I replaced it and downloaded the lastest clearos from the downloads page and wrote it to usb with dd. When I tried to install it it fails and says pane is dead and gives an error: Glib.Error g-io-error-quark: timeout. I have attached a few photos. The desktop is an i5 6400 with 16gb ddr4 and was running fine before. Any help would be appreciated.
In Installation
Share this post:
Responses (11)
-
Accepted Answer
The disk will not spin at all anymore. Either the motor died or the controller card caused it. That makes me wonder if there was some sort of power surge although It was on a ups with a surge protector. I did once have lightning hit my house and blow through all the surge protectors and kill a couple machines. Anyway I am going to try to install windows, but that will have to wait until tomorrow. I am thinking maybe something failed in the uefi becuase I can see from the command line al the files are installed, Just not in the boot sector will not write. -
Accepted Answer
Perhaps some hardware is starting to fail - power supply or memory going bad for example... Does a trial install of another OS succeed or fail - e.g. Windows or Desktop version of Fedora? Fails? run memory tests for a few hours... substitute another Power supply etc. What is the failure mode of the original disk drive... -
Accepted Answer
-
Accepted Answer
-
Accepted Answer
I've deleted you extra posts.
You are showing a lot of pcieport errors. Are you sure your system is healthy? Device ID 8086:a116 is a 100 Series/C230 Series Chipset Family PCI Express Root Port #7. I don't know if it means the hub is throwing the error or if a connected device is. Do you have any PCI-E cards in the server? Can you try moving them to a different port or temporarily removing it/them completely. -
Accepted Answer
-
Accepted Answer
-
Accepted Answer
I’m no wizard, but just a couple thoughts. Did you verify your ClearOS iso download using a checksum? Read this
Does your desktop PC have a cd or dvd? If so, have you tried burning the iso and installing from this?

Please login to post a reply
You will need to be logged in to be able to post a reply. Login using the form on the right or register an account if you are new here.
Register Here »